SIM IRM
CIM if both combined
in double module
PIM
HUB HM1
Schematic shows audio source located in Family Room. An alternative to this is shown with a direct audio source located
with the HUB. All cables are CAT5/6 UTP, maximum cable per zone 150m (excluding power only cables). No single cable
run to exceed 50m; maximum active speaker to passive speaker length 30m; maximum power cable using PSM45 40m.
En suite bathroom
demonstrates how a
single speaker in mono
mode can be used in
smaller rooms, in this
example as a sub-zone of
the bedroom. This allows
a local power supply
(PSM45) centrally fi tted.
When installed like this
the maximum cable length
for the PSM45 is 40m. If
cable length 40-50m then
use PSM130.
Kitchen/Dining room
demonstrates how large
areas can be covered
by up to three pairs of
speakers using sub-zone
connections. This shows
the use of a locally fi tted
power supply (PSM45).
Kitchen/Dining room
BedroomEn suite
bathroom
Family room Equipment area/understairs cupboard etc
Diagram showing a basic overall wiring scheme
Patch panel is convenient but not essential.
Quick Install Card 02 ii 5/6/03, 10:09:43 am
To Next Page
Loading...