Systemline SLM2 - System Configuration Switches; Mono vs. Stereo Output; Input Source Selection; Local Input Management

1. Put the zone into
standby
2. Enable the local input 3. Disable the local input
Remote
RJ45
Remote audi
o
Blue - Green - Blue - Green - Red
To enable/disable a local input
To set the mono/stereo switch
To set the hub direct/remote switch
MonoStereo
Red Blue - Red - Blue - Red
RCA Phono
Direct Audio
Direct
Press
simultaneously
Press
simultaneously
Quick Install Card 02 v 5/6/03, 10:16:34 am