channel.
- To switch off the appliance, switch the on/off button to the off position.
Trimming eyebrows
- Comb your eyebrows in the direction of hair growth.
- Choose the short or long comb, depending on the desired hair length.
- Place the eyebrow comb onto the trimming head.
- Make sure that your eyebrow comb has been properly placed into the grooves on both
sides.
- Move the comb over the eyebrow from outer tip of the eyebrow towards the base of the
nose (against direction of hair growth).
- After use, make sure to switch off the unit.
Tip: We advise you to start trimming with the long comb. If you think your eyebrows are still
too long after this, use the short comb.
CLEANING & MAINTENANCE
- Clean the appliance immediately after use and when lot of hair or dirt has been
accumulated on the cutting element.
- Do not tap on the cutting element.
- Do not use any sharp objects to clean the cutting element
- Make sure the appliance is switched off.
- Remove the battery from the battery compartment
- Use the supplied brush to remove the remaining hair from the blade and from the combs.
- The blade can be cleaned under hot running water as shown above (Fig1) and for a better
cleaning, remove the trimming head (2) by turning it clockwise.
- Wipe the outer surface of the unit with a soft damp cloth, provided water does not get
inside the unit.
- Do not use any chemicals or abrasive liquids to clean the unit.
- Let all parts dry completely before you use the appliance again.
- Insert the battery back into the battery compartment
SPECIFICATIONS
- Nose, ear and eyebrow trimmer
- Reciprocating movement to facilitate hair removal
- Light weight and easy to use
- Detachable head for easy cleaning
- On and off switch
- Blade material: Stainless steel
- Water resistant: IPX4
- Minimum and maximum length cut: 0 – 7mm.
- Precision adjustment: 0mm, 4mm, 7mm.
- Power: 1.2W
- RPM: 5000 ±10%
- Operates with 1 “AA” -R6 battery (Not included)
To Next Page
Loading...