0FL-4070-000, 13 Dec 2002 1 (2)
English
STR150
®
Wall Module with Display
User's Manual
0FL-4070-000
Connecting STR150 to a TAC Xenta 100 Family
Controller
TAC Xenta Controller
(101-VF, 102-ES,103-A or 104-
D1
X1
M
Mode
Data
M
11
12
13
STR150
CONNECTING
Wiring
Cable type ............................. Twisted pair, unshielded
Cable size ................................. Min 0.7 mm
2
(19
AWG)
Distance ............................................ Max 30 m (100 Ft)
ATTACHING/REMOVING THE FRONT
The front panel is
attached to the base-
plate using four clamps,
two at the top of the front
panel and two at the
bottom.
When removing the front
panel use a screwdriver
(or similar) and push
gently to unhook the
clamps at the top or
bottom of the front panel.
To avoid base-plate deformation, be careful when
tightening the mounting screws. Note that the
enclosed screws are mainly intended for the US
and Australian markets.
REMOVING THE CORE
The core panel is
attached to the base-
plate using two
hinges. Remove the
core panel by pushing
the bottom of the core
panel upwards, then
unhinging the core
panel from the base-
plate.
MOUNTING, CABLES
Cables
Cables
Cables
Cables
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Need help?
General