T-Drill PLUS 115 SS: - Page 75

Safety Data Sheet
according to Regulation (EC) No. 1907/2006 (REACH)
according to Regulation (EU) 2015/830
Article No.: 317500
Print date: 12.04.2021
Version:
18.0
Isoform TD 50
Revision date: 07.04.2021
EN
Issue date: 07.04.2021
Page 3 / 7
Advices on safe handling
Avoid contact with skin, eyes and clothes. When using do not eat, drink or smoke. Personal protection equipment: refer to
section 8. Do not empty containers with pressure - no pressure vessel! Always keep in containers that correspond to the
material of the original container. Follow the legal protection and safety regulations.
7.2.
Conditions for safe storage, including any incompatibilities
Requirements for storage rooms and vessels
Storage in accordance with the Ordinance on Industrial Safety and Health (BetrSiVO). Keep container tightly closed. Do not
empty containers with pressure - no pressure vessel! Smoking is forbidden. Access only for authorised persons. Store
carefully closed containers upright to prevent any leaks.
Further information on storage conditions
Store in a well-ventilated and dry room at temperatures between 5 °C and 35 °C. Keep container tightly closed. Smoking is
forbidden. Access only for authorised persons. Store carefully closed containers upright to prevent any leaks.
7.3.
Specific end use(s)
Observe technical data sheet.
SECTION 8: Exposure controls/personal protection
8.1.
Control parameters
Occupational exposure limit values:
not applicable
8.2.
Exposure controls
Provide good ventilation. This can be achieved with local or room suction.
Personal protection equipment
Respiratory protection
Avoid breathing spray.
Hand protection
For prolonged or repeated handling the following glove material must be used: NBR (Nitrile rubber), PVC (polyvinyl chloride),
CR (polychloroprene, chloroprene rubber). Barrier creams can help protecting exposed skin areas. In no case should they be
used after contact.
Eye/face protection
Wear closely fitting protective glasses in case of splashes.
Body protection
Wear suitable protective clothing and gloves.
Protective measures
After contact clean skin thoroughly with water and soap or use appropriate cleanser.
Environmental exposure controls
Do not allow to enter into surface water or drains. See section 7. No additional measures necessary.
SECTION 9: Physical and chemical properties
9.1.
Information on basic physical and chemical properties
Appearance:
Physical state:
Liquid
Colour:
yellow
Odour:
mild
Odour threshold:
No data available
pH at 20 °C:
not applicable
Method: DIN 51369
Melting point/freezing point:
No data available
Initial boiling point and boiling range:
not determined
Flash point:
> 220 °C
Method: ISO 2592
Evaporation rate:
No data available
flammability