T.I.P. CHLOR COMFORT 15000 User Manual (English)

Questions and Answers:

S
Sarah GarciaAug 8, 2025
Why does my T.I.P. Swimming Pool Filter pump stop after a short time?
- F
  Frank DavenportAug 8, 2025
  If your T.I.P. Swimming Pool Filter pump stops shortly after starting due to the thermal motor protection feature activating, it could be due to several reasons. First, ensure that the electrical supply matches the specifications on the type plate, using a GS-compliant device to check the voltage. Also, check for and remove any blockages in the pump or intake openings. The liquid temperature might be too high, so ensure it's within the acceptable range. Finally, eliminate any causes of the pump running dry.
P
Paula PittsAug 15, 2025
What to do if T.I.P. Swimming Pool Filter motor is running, but no liquid is being discharged?
- J
  Julia PowellAug 15, 2025
  If your T.I.P. Swimming Pool Filter motor runs but the pump isn't discharging liquid, first ensure the pump housing is filled with liquid and that the water level in your pool is above the pump's suction point; also, make sure the strainer is free of dirt. Check for air leaks by ensuring connection points on the intake line are tight and that there are no siphons, kinks, counter-slopes, or narrow spots in the intake lines. Lastly, inspect the check valve (non-return valve) for blockages or damage, cleaning or replacing it as needed. Also, clean the insert of the pump and check any blockage of the impeller.
H
Heather EllisonAug 22, 2025
How to troubleshoot a T.I.P. Swimming Pool Filter when the pump is not discharging liquid and the motor isn't running?
- L
  Lindsay HermanAug 22, 2025
  If your T.I.P. Swimming Pool Filter pump isn't discharging liquid and the motor isn't running, the issue could stem from several causes. Begin by checking for voltage using a GS-compliant device and ensure the plug is correctly positioned. If voltage is present, the thermal motor protection may have been triggered; disconnect the pump, let it cool, and address the cause. If neither of these resolves the issue, the capacitor may be defective, and you should contact customer service.
A
Aaron BrownAug 31, 2025
What causes noise in T.I.P. Swimming Pool Filter during operation?
- M
  Michael WoodsAug 31, 2025
  Noise in the T.I.P. Swimming Pool Filter pump during operation can be caused by several factors. It could be a defect bearing or a fault in the impeller, in which case you should contact your local service partner or the manufacturer. Air penetrating the intake line can also cause noise; refer to section 2 of this table for solutions. Check for and clear any blockage during aspiration by checking and cleaning the suction hose. Finally, a disturbance while sucking can cause noise; improve the suction inlet by ensuring it is under the water level, reducing the number of screws, and assembling a pipe with a larger diameter.