5.4. Cleaning attachments
Fit one of the attachments on the suction tube.
Suction attachment (A): Suitable for surface cleaning and light
soiling.
Brush attachment (B): For targeted and intensive cleaning.
(Fig. 4)
Fig. 4
5.5. Starting the device
Switch the device on or off at the handle by pressing the switch (I
= on, O = off) (Fig. 5).
Fig. 5
5.6. Use
When in use, lower the device at least 40 cm into the pool, although no
more than 190 cm (with the telescopic tube fully extended) (Fig. 6). The
suction tube including attachment must be immersed sufficiently deeply
that the attachment touches the bottom. Clean the pool floor and wall
with a light back and forth motion. Observe the maintenance instructions
for a consistent cleaning effect.
ATTENTION! Never immerse the device completely under water. This
can cause damage to the battery and the charging unit.
F
Fig. 6
6. Maintenance
6.1 Maintenance and cleaning
Do not use aggressive solvents or cleaning agents.
6.1. Filter cleaning
• To open the device for filter cleaning see 5.1.
• Remove all dirt and water from inside the filter.
• Clean the filter regularly.
• The cleaning intervals depend on the degree of dirty water.
Fig. 7
To Next Page
Loading...
Need help?
General
