3 User's Guide for System Configuration High Security Systems, Technical Manual
14 (20) TAC AB, Nov 2006
04-00007-01-en
Note that the computers running the TAC Vista servers have to be
defined in this domain. Those computers also have to specify this
domain as their primary logon domain in the network setup.
Executing TAC Vista Server as a Service under Windows NT.
1 Log on as VistaAdmin in the domain PlantTAC on the TAC Vista
Master PC.
2 Install TAC Vista.
3 After installation, issue the following commands from a command
window (Start button-Run-Open:command):
>cd \tac330
>tacos /service
>exit
4 Start the TAC Vista Setup program and select the Authority sheet.
5 In the Vista security level area, select High Level (Use NT
Accounts).
6 In the Protected by account area, select This Account and enter
"PlantTAC\VistaAdministrators". Also select "Current user" in the
"Windows user in TAC Vista" sheet.
7 On the control panel, double-click Services. You will find
"TACOS" as a service.
8 Highlight TACOS and click Startup ...
9 Select Startup Type: Automatic which makes TACOS start auto-
matically at Windows startup.
10 Select Log On As: This Account and enter "PlantTAC\VistaAd-
min" and password for this administrative account.
11 Click OK. Finally, start the TAC Vista Server by clicking Start
button.
12 Repeat the steps above on the TAC Vista Slave computer as well
and set up the TAC Vista network between the computers.
To Next Page