Operator’s manual
1. On/off switch
2. Engraving tip
3. Stroke adjustment dial
4. Tip release screw
5. Power cord
CAUTION
Thoroughly read and understand all instructions before using this product.
S2: 30 min.; Indicates operating time at no more than 30 minutes at rated
load followed by a complete cool down of the tool.
Specifications
Input power: 15W
Power supply: 120V~60Hz (US)
Engraving bit: Tungsten Carbide Tipped steel
Safety instructions
WARNING.
Read and understand all instructions. Failure to follow all instructions
listed below may result in electric shock, fire and/or serious injury. The
term “power tool” in all of the warnings below refers to your mains-operated
(corded) power tool or battery-operated (cordless) power tool.
- 01 -
1
3
2
4
5
7200spm
To Next Page
Loading...