Sec 3.3
SAFETY ANKLE LEASH ATTACHMENT:
STEP 1: Open the Velcro tabs on the end of the leash
STEP 2: Insert the tab through the D-Ring located at the tail of your board.
STEP 3: Fold the tab over itself and onto the Velcro. Repeat for the secondary tab to secure the
leash in place.
STEP 4: Attach the cuff end of the leash just below your knee/above your calf.
The leash prevents you from being separated from your board in the event you fall off and
cannot get back to the board.
The leash can save your life if you fall off your board
and the wind or current pushes your board away from
you faster than you can swim back to it!
To Next Page
Loading...