-6-
right or left of the main body.
2) Fit the sake meter in the sake meter fittings.
3) Remove the cap that is attached to the sake meter
connection port.
4) Insert the joint part of the sake meter into the hole
located on the side surface of the main body, and
screw it in the sake meter connection port.
Leakage of sake will occur if this screw-in process
is awkwardly followed.
7.Clean the sake warmer heat
exchanger pipe.
This product is already cleaned inside before
shipment. When you are going to use it for the first
time or after a long period of non-use, clean it
according to “Daily maintenance” in the section of
“After use” herein.
Caution
• Hot water comes out of the nozzle while the inside
is cleaned. Pay attention to a possible accident of
scalding, etc.
<Fig. 6>
To Next Page
Loading...
