To Next Page

To Previous Page

574 TOPA-SV-024 Test Unit TM8100/TM8200 Service Manual

34.2.4 Rx / Tx/PTT Switch

This 2-way toggle switch is used to switch between receive and transmit mode.

■ When set to Rx, the PTT line is switched to high impedance.

■ When set to Tx/PTT, the PTT line is pulled to ground.

34.2.5 Speaker / Radio / Load Switch

This 3-way toggle switch is used during receive audio tests to switch the audio

to the test unit speaker (Speaker), to the radio’s internal speaker (Radio) or to

a dummy load consisting of R1 and R2 (Load).

Note This switch does not disconnect the radio’s internal speaker on

mobiles. If the switch is set to Speaker or Load, this simulates an

external speaker being connected in parallel to the radio’s internal

speaker.

With all settings, a low level audio signal is available for testing through

the SINAD port.

Portable ■ When set to Speaker, only the speaker of the test unit is active.

■ When set to Radio, only the speaker of the portable is active.

■ When set to Load, no speaker is active. The audio signal is terminated in

the test unit dummy load.

Mobile ■ When set to Speaker, the speakers of the test unit and the mobile are

both active. The speaker of the mobile cannot be disconnected.

■ When set to Radio, only the speaker of the mobile is active.

■ When set to Load, the speaker of the mobile remains active.

Tait TM8115 Service Manual

Other manuals for Tait TM8115