13 General Information Tuneup
August 2004© Tait Electronics Ltd
Install Applications
The upper two buttons in the
Contents
window of the product support
CD allow for the installation of the programming and calibration
applications:
1. Click the
“Programming”
button. Installation of the programming
application begins automatically. Follow the instructions on the
screen to complete the installation.
2. Click the
“Calibration”
button. Installation of the calibration
application begins automatically. Follow the instructions on the
screen to complete the installation.
3. The
Contents
window remains open following installation of the
above applications. Investigate the remaining features of the
product support CD as described below, or click the
Close
button
to remove the window.
4. Remove and store the product support CD.
View Documents The middle six buttons in the
Contents
window of the product support
CD give access to the documents stored on the CD:
To view any document click the corresponding button. The Adobe
Acrobat Reader application needs to be installed on the test PC.
Figure 1.3 The
Contents
window of the product support CD
To Next Page
Loading...
