TALARIA STING - Page 29

www.aebikes.com.au
|
sales
@
aebikes.com.au
|
page 025
ITEM
ERROR CODES
(MX VERSION)
ERROR CODES
(L1E VERSION)
DESCRIPTION ERROR ANALYSIS SOLUTIONS REMARKS
41 E42 00C00 Motor overheat error.
Long time peak
power riding will
cause the motor to be
overheated, or motor
inner temperature
sensor got a poor
contact, or motor inner
temperature sensor to
be broken.
1. Stop riding until the
motor's temperature
r e t u r n t o n o r m a l .
2. Check whether the
magnetic encoder
is loose or broken. If
it's broken, need to
replace with new one.
42 E43 00D00
Motor temperature
sensor error.
Long time peak
power riding will
cause the motor to be
overheated, or motor
inner temperature
sensor got a poor
contact, or motor inner
temperature sensor to
be broken.
1. Stop riding until the
motor's temperature
r e t u r n t o n o r m a l .
2. Check whether the
magnetic encoder
is loose or broken. If
it's broken, need to
replace with new one.
43 E44 00E00
Controller overheat
error.
Long time peak power
riding will cause
the controller to be
overheated
Stop riding until the
controller return to the
normal temperature.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
44 E45 00F00
Controller
temperature sensor
error.
Long time peak
power riding will
cause the controller
to be overheated, or
controller temperature
sensor got a poor
contact, or controller
temperature sensor to
be broken.
Stop riding until the
controller return to the
normal temperature.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
45 E46 01000 Current sensor error. Current sensor failure.
Please send the bike
to the nearest dealer to
inspect and repair.
46 E47 02000
Motor lack of
phase error.
1. Circuit breaker
i s n o t s w i t c h e d o n .
2. Motor phase wires
(U/V/W) loose or
incorrect connection.
1. Switch on the circuit
breaker, and restart
the bike.
2. Turn off the bike,
and switch off the
circuit breaker. Then,
check the whether
the motor phase wire
terminal got loose,
or broken. And then,
check whether the
motor outlet phase
sequence corresponds
to the U / V / W on
the controller. Finally,
check whether
the magnetic
encoder output wire
corresponds to the
yellow, green and blue
wires on the harness
assy.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.