TALARIA STING - Page 30

www.aebikes.com.au
|
sales
@
aebikes.com.au
|
page 026
ITEM
ERROR CODES
(MX VERSION)
ERROR CODES
(L1E VERSION)
DESCRIPTION ERROR ANALYSIS SOLUTIONS REMARKS
47 E48 03000
Motor locked-rotor
protection error.
During the riding, if the
rear wheel is stuck,
and cannot rotate, or
the motor, gearbox,
brake,chain are stuck,
will cause the discharge
current load to be equal
or greater than the
protection value. Then,
cause the error.
1. Turn off the bike, as
well as to switch off the
circuit breaker. Then,
put the bike on a lifer,
to check whether the
rear wheel can rotate
normally, if anything
stuck the rear wheel,
please eliminate it.
And please also check
whether there're
things stuck the motor,
gearbox, chain and
brake. If yes, please
eliminate it.
2. Choose the right
road condition to ride
t h e b i ke .
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.
48 E49 04000 Communication Error.
CAN communication
wire loose, fall off or
hardware failure.
Turn off the bike, as
well as to switch off
the circuit breaker.
Then, check the all
the CAN connections
on the bike to see
whether there's the
loose or breaks. (Dash
connection, controller
connection, battery
pack communication
connection. These 3
positions have CAN
connections). If there's
the loose or breaks,
just repair them, and
re-start the bike, the
error will be solved.
If the solution cannot
solve the error,
please send the bike
to the nearest dealer
to inspect and repair.