Handle until unit activates. Begin hair
treatment procedure. Starting at the top
while holding the section of hair with one
hand and the Split-Ender PRO2 with the
other, work towards the ends and slowly
comb the hair with the Split-Ender PRO2
all the way to the bottom. Use a slow,
even motion, just like you would use with
a flat iron or hair brush. Repeat 3 times
per section! (See Fig. 5)
Note: If you feel that is pulling the hair
then you either have too much hair on
the hair plate or the hair is not free of
tangles. Take some hair out, brush it
and try again.
Step 6. Treat every section of hair 3
times per section and continue with the
same amount of treatments per section
to insure an even trim all around the
head of hair by the time that you are
done. After you finish every section of
hair, clip it to the side separating it from
the untreated hair. (See Fig. 6) Select
another small, "THIN" section of hair and
repeat treatment until that working side is
finished. Repeat on the other side until
both sides are completed.
From time to time while you are treating
the hair, you will see the Hair Chamber
housing getting full of little bits of hairs.
(See Fig. 7) Stop for a minute and empty
the Hair Chamber pouring it over a sheet
of paper or counter top as you go. (See
Fig. 8) This insure that the blades
housing
is clean during treatment as you go for a better Split-Ender PRO2 performance.
(Please go to "QUICK HAIR CHAMBER CLEAN UP" section for how to remove
hair off the Hair Chamber safely).
Fig. 5
Fig. 6
Fig. 8
Fig. 7
9
To Next Page
Loading...