QUICK HAIR CHAMBER CLEAN UP
Fig. 1
Fig. 2
Fig. 3
Fig. 4
1- With the Hair Plate in the open
position, hold by the Handle with one
hand while gently pressing down on the
Clear Window ARROW Mark just as
shown on Fig. 1.
2- Proceed to slide the Clear Window off
the Hair Chamber or Blade Housing.
(See Fig. 2)
3- On a sheet of paper or counter top
dump the hair pieces from the Hair
Chamber! (See Fig. 3)
4- Using the Cleaning Brush provided,
brush out all of the hairs from the Blade
and Housing. Note that the Cleaning
Brush hairs may get stuck on the blades
sharp edges so do it carefully. (See Fig.
4) After you have finished, install the
Clear Window back to the housing. Hint!
Unit will not turn ON if clear window is not
installed due to a internal safety switch!
11
To Next Page
Loading...