Fig. 3
Fig. 2
2- Reverse the Blade Housing and spray
Disinfectant to the entire Blade Housing,
Brushes and Blade area. (See Fig. 2)
IMPORTANT! Make sure to
always clean all the hairs from the
gears and in between the Activating
Metal Contacts as it can cause the
MOTOR NOT to TURN ON.
3- Also apply Spray Disinfectant to the
Hair Plate and Spacers. (See Fig. 3) Is
always good to have a sanitised piece of
cloth that you can use to clean any
residue off from all parts after the 10
minutes of Disinfectant Solution time
frame is over.
4- You can also lay all parts that make
contact with the hair down on a towel
(after cleaning all hair off all parts) and
Spray Disinfectant directly to each part if
you don't want to have contact with the
Spray Disinfectant solution on your
hands. It is always recommended to
wash and disinfect your hands with soap
and hand sanitiser to prevent passing
any germs from your hands back to any
parts or the Split-Ender PRO2 when
assembling it back together.
5- To extend the life of your cutting
blades always keep it clean and follow
the steps above.
13
To Next Page
Loading...