Talk-a-Phone ETP-100E

To Next Page

Elevator Emergency Alarm Phone

Software Programming Model #ETP100E

A. Quick Programming Guide

Programming your Talk-A-Phone unit is, in most cases, quite simple. While it is

recommended that you read the complete instructions below before you begin,

the

following quick guide will serve many applications. After entering each code you

should hear one beep, confirming the acknowledgement of the command:

Call your emergency/information phone 224-513-5739. It answers with a series of

tones.

2. Enter the default Guard Access Code: *4**

3. Enter the primary phone number your Talk-A-Phone unit should dial upon

activation: *13* 847-362-2121*

4. Enter the secondary phone number your Talk-A-Phone unit should dial if the

primary number is busy or does not answer (optional): : *23* 847-362-4424*

5. If the Talk-A-Phone unit will be an extension of a phone system (i.e. on a PBX),

enter these three codes into the Emergency/Information phone, each followed by

the acknowledgement beep: *55*, *18*5*, *14*3*.

6. If your phone has the Intelli-Voice Option (the model number ends in "V"),

enter

*58* to record a 10 second message. The Talk-A-Phone unit will beep once

before the recording starts and beep the second time at the end of the message

recording.

7. Enter # to hang up the Talk-A-Phone unit.

Enter *59* to play back the recorded message.

Main Page

Need help?

Do you have a question about the Talk-a-Phone ETP-100E and is the answer not in the manual?

Summary

Hardware Installation

100 Series Indoor Phones

Installation steps for indoor phone models.

400 Series Outdoor Surface Mount Phones

Mounting instructions for outdoor surface phones.

400 Series Outdoor Flush Mount Phones

Installation procedures for outdoor flush mount phones.

ETP-103 Series Phone Installation

Specific mounting and wiring for ETP-103 models.

Software Programming

Quick Programming Guide

Step-by-step guide for initial phone setup.

General Programming Instructions

Overview of touch-tone programming procedures.

Access Codes Management

Setting and using Guard and Master Access Codes.

Primary & Secondary Dialing Codes

Codes for setting emergency and backup phone numbers.

Speaker & Microphone Control Codes

Intelli-Voice Message Codes

Auxiliary Device Activation Codes

Controlling auxiliary outputs via phone commands.

Operation Codes

PBX;Timing Configuration Codes

Settings for PBX integration and call timing.

Programming Command Summary

Alphabetical listing of all programming codes and functions.

Operation

Calling the Phone from Guard Station

Answering the Emergency;Information Phone

PBX System Integration

Configuring the phone for use with PBX systems.

Auxiliary Circuits Functionality

Keypad Model Operation

Special Keypad Model ETP-400 DKV

10-Number Autodialing Keypads

Autodialing Programming

Setting phone numbers for keypad buttons 0-9.

Keypad Operation

Frequently Asked Questions

Master Access Code Recovery

Resetting Programming Errors

Restoring factory settings after programming mistakes.

Live Mode Programming Access

Basic Trouble-Shooting

Phone Line Specifications

MODE I Operation Requirements

MODE II and MODE III Operation