EasyManua.ls Logo

Talking Products Micro-Speak Plus 4GB User Manual

Talking Products Micro-Speak Plus 4GB
5 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
4GB Micro-Speak Plus User Guide Text
Important Notes
Please read all instructions carefully before using this product and retain this document for future reference.
Micro-Speak is not recommended for children under 3 years.
Do not allow your Micro-Speak to come into contact with water.
Micro-Speak contains a non-replaceable, rechargeable battery. Please do not attempt to open the case and
remove the battery. Warranty is void if the case is opened for any reason.
To avoid damaging your ears with excessive noise, please adjust the volume level before you listen to a track
using earphones.
Features
The following two paragraphs will assist users with a visual impairment to locate buttons and features.
The speaker and microphone are hidden behind the grill on the top half of the unit. The Record Button is located
below the speaker grill in a central position. There is an LCD display below the Record Button and three
navigation buttons are located below the LCD display. These navigation buttons consist of a square Play/Pause
button in the centre with the Previous Button located to the left and the Next Button to the right.
There are volume control buttons and an earphone socket located on the right side. The Power ON/OFF switch is
located on the bottom edge to the left side. Slide the switch to the left positon to turn ON and slide to the right to
turn OFF. A USB Socket is located to the right of the Power Switch.
Audible prompts and beep sound confirmations will assist you with certain functions during use.
Special Note
The backlight for the LCD screen has been turned off for this model. This will not matter for the majority of users,
but it has been done due to the restrictions of the software and primarily to assist users with low vision. Please
note the backlight on the LCD screen is only enabled for the standard version of the Micro-Speak but that model
does not include audible prompts.
Welcome message
When using Micro-Speak for the first time slide the Power Switch to the ON position and the MICRO-SPEAK
name will appear on the screen for 3 to 4 seconds. Micro-Speak will then go into Play Mode and the pre-recorded
welcome message will be ready to play. Press the Play/Pause button once to hear the message and alter the
volume to suit your requirements.
NOTE: After the Micro-Speak is powered ON, you will hear an audio prompt that will state the unit is ready to use
followed by the status of the Battery. There are four battery levels, comprising of High, Medium, Low and Empty.
Battery charging instructions are detailed below.
Question and Answer IconNeed help?

Do you have a question about the Talking Products Micro-Speak Plus 4GB and is the answer not in the manual?

Talking Products Micro-Speak Plus 4GB Specifications

General IconGeneral
Storage Capacity4GB
Recording FormatWAV
Battery LifeUp to 10 hours
CategoryVoice Recorder
Product NameTalking Products Micro-Speak Plus 4GB
Power Source2 AAA batteries

Summary

Important Notes and Safety

Safety and Usage Precautions

Key safety guidelines and usage warnings for the Micro-Speak device, including age restrictions and water avoidance.

Audible and Beep Feedback

Explains the use of audible prompts and beep sounds for user feedback during operation.

Micro-Speak Features Overview

Button and Feature Locations

Locates physical buttons, speaker, microphone, and display on the Micro-Speak unit.

LCD Backlight Note

Details why the LCD screen backlight is disabled for this model and its benefits for low vision users.

Welcome Message and Setup

Describes the initial startup sequence, welcome message, and initial volume adjustment.

Charging the Micro-Speak

Charging Procedure

Step-by-step guide for charging the Micro-Speak battery via USB.

Initial Charging Recommendations

Advice on initial charging cycles to maximize battery capacity and longevity.

USB Mains Plug Adapter Charging

Alternative method for charging the Micro-Speak using a USB mains adapter.

Recording Audio

Recording Process

Instructions on how to start, pause, resume, and finish recording audio.

File Saving and Playback Preparation

Details on how recordings are saved, named, and prepared for playback.

Playback and File Management

Playback and Pause Control

How to start, pause, and resume audio playback using the Play/Pause button.

Fast Forward and Reverse

Using Previous/Next buttons to navigate quickly through audio tracks.

Track Navigation

How to select and play different audio tracks using navigation buttons.

Volume Control

Instructions for adjusting the audio volume using the '+' and '-' buttons.

Earphone Socket Usage

Guidance on using the earphone socket for private listening.

Deleting Tracks

Steps to delete audio files directly from the device or via a computer.

Connecting to a Computer

Connecting for File Transfer

How to connect the Micro-Speak to a computer for data transfer and driver installation.

Device Operation and Specifications

Power Saving Feature

Explains the automatic power-off function after 15 minutes of inactivity.

Technical Specifications

Details on recording format, capacity, battery, frequency response, and physical size.

Troubleshooting Common Problems

Solutions for issues like no display, playback errors, and recording failures.

Support and Contact Information

Warranty Terms

Information on the one-year warranty, exclusions, and non-replaceable battery.

Contact Details

Provides email, postal address, and phone number for customer and technical support.