Need help?Do you have a question about the Tamiya RAYBRIG NSX 2000 and is the answer not in the manual?
General| Brand | Tamiya |
|---|---|
| Model | RAYBRIG NSX 2000 |
| Category | Motorized Toy Car |
| Language | English |
Lists recommended RC units, including 2-channel systems and FET amplifier types for optimal performance.
Specifies the need for a 7.2V Ni-Cd Racing Pack and compatible charger for the model's operation.
Lists Tamiya polycarbonate and plastic paints, and essential tools required for assembly and finishing.
Provides crucial safety warnings for assembly and operation, including handling tools and small parts.
Explains the function of the transmitter, receiver, and servo in a 2-channel R/C system.
Emphasizes reading instructions, checking parts, and applying grease where indicated for proper assembly.
Step-by-step instructions for assembling the differential gear unit, noting the need for two units.
Details the process of attaching the rear suspension arms to the chassis using specified screws.
Covers the assembly and mounting of rear axle components, including bearings and drive shafts.
Instructions for assembling the front suspension arms and mounting the front axle components.
Guides on attaching the rear damper stay and related parts to the chassis.
Details the construction of the steering linkage, including arms, rods, and pivot balls.
Instructions for mounting various chassis components, including gearbox joints and drive shafts.
Procedures for checking the radio control system, including servo neutral positioning and transmitter setup.
Steps for connecting steering rods to the steering arms and setting up the steering linkage.
Instructions for installing the C.P.R. unit, combining speed control and receiver, onto the chassis.
Guidance on connecting the motor to the speed controller and managing motor cables correctly.
Details the process of fitting the propeller shaft into the chassis, noting where to trim if necessary.
Steps for assembling and mounting the rear gearbox, including gear ratios and optional parts.
Instructions for mounting the front gearbox unit to the chassis, including toe-in adjustment checks.
Guides on fitting the gear cover over the gearbox assembly and passing the antenna wire.
Step-by-step guide for assembling shock absorbers, filling them with oil, and removing air bubbles.
Explains how to correctly connect motor cables to the speed controller, matching colors.
Instructions for mounting the rear shock absorbers, including spring compression and part orientation.
Guides on fitting the front shock absorbers, noting spring compression and part orientation.
Details how to assemble the wheels, including fitting tires, inner sponges, and securing with tape.
Instructions for mounting the assembled wheels onto the car chassis, securing with lock nuts.
Guides on installing the battery pack, connecting it, and ensuring proper antenna setup.
Instructions for cutting and preparing the car body for painting, including making holes.
Explains how to wash and prepare the body shell before applying paint for optimal adhesion.
Details the painting process, including applying masking seals and colors from the inside.
Step-by-step guide on how to cut and apply stickers (markings) to the body, ensuring proper placement.
Instructions for applying decals to the wheels, side mirrors, and wing for detailed finishing.
Guides on fitting various body parts like mirrors, wing mounts, and adjusting wing angle.
Instructions for attaching the prepared body shell to the car chassis using snap pins.
Step-by-step guide on how to safely operate the RC car, including switch order and disconnection.
Outlines essential safety rules for running the RC car, avoiding hazards and wet conditions.
Provides advice on how to practice driving techniques, such as cornering and figure-eights.
A guide to diagnose and resolve common problems encountered with the RC car's operation.
To Next Page