6. Assemble the TAMJETS A4 assembly jig using CA+. With the Fuselage
positioned in the jig, slide the Wings into the fuselage. Insure that the wings are
tight against the fuselage sides. When properly fitted to the fuse, the ROOT of
the wings should be resting on the JIG SADDLES. Support the wings at the tips
using the jig supports, check the Dihedral as it shall be 0 degrees from wing tip
to wing tip as measured at the trailing edge AND 0 degrees INCIDENCE
measured at the wing root. When satisfied, proceed to step 7.
Use Velcro straps to secure Fuselage to Jig.
To Next Page
