Tanda Me elos User Manual (English)

Questions and Answers:

M
Maria RogersJul 26, 2025
What to do if error light is blinking on Tanda Me elos Hair Removal System?
- T
  Theresa RojasJul 26, 2025
  If the error light is blinking on your Tanda Hair Removal System, there are several possible causes: 1. If the button was pressed for more than 10 seconds, release it, and the system will return to standby mode. 2. If the grip sensors were held during the start-up test, place the applicator in the cradle and press the power button again. 3. If there is no cartridge level indication, try pulling out the cartridge and re-inserting it. If that doesn't work, insert a new cartridge.
A
Austin MoranJul 30, 2025
What to do if continuous error light on Tanda Me elos Hair Removal System?
- L
  lesliegreenJul 31, 2025
  If you're experiencing a continuous error light on your Tanda Hair Removal System, you may need to reset the system. To do this, disconnect the power cord and wait until all the lights are off (this may take up to two minutes). Then, reconnect the power cord and turn the system back on.
C
Charles FischerAug 4, 2025
Why no elos pulses from Tanda Me elos Hair Removal System?
- S
  Stephanie LeeAug 4, 2025
  If your Tanda Hair Removal System is not emitting elos pulses, ensure that all three conditions are met: the elos button is pressed, you are touching the grip sensors, and the RF bars are in contact with the treated area. The device will emit elos pulses only when all these conditions are met.
K
Kevin WilliamsAug 8, 2025
What to do if elos level lights are blinking and IPL light pulses stop on Tanda Hair Removal System?
- D
  Dennis JohnsonAug 8, 2025
  If the elos level lights are blinking and the IPL light pulses stop on your Tanda Hair Removal System, it could be due to the ambient temperature being too high. Try pressing the elos button again. If that doesn't work, move to a cooler area where the temperature is less than 30 degrees Celsius/86 degrees Fahrenheit.
D
Donna OlsonAug 12, 2025
What does it mean if epilator/shaver lights are blinking on Tanda Hair Removal System?
- N
  Nicole BrewerAug 12, 2025
  If the epilator/shaver lights are blinking on your Tanda Hair Removal System, it indicates that the epilator/shaver slot is empty. To resolve this, insert the epilator, shaver, or a protective cap into the slot.
D
derrickbernardAug 17, 2025
What to do if elos white light is blinking on Tanda Me elos?
- K
  Krista WalkerAug 17, 2025
  If the elos white light is blinking on your Tanda Hair Removal System, it means the elos slot is empty. You need to insert either the elos protective cap or an elos cartridge into the slot.