5
General Instructions
1/4” Spanner
Bit (1)
End Plug Assembly (1)
DC-111 Silicone Grease (1)
Compression
Spring (1)
Valve Repair
Assembly (1)
Spray Valve Body Assembly
B-0108 Valve Repair Kit -- 108V-RK
1. Shut off water supply to spray valve.
2. Using the 1/4” spanner bit, unscrew the end plug.
Note: Be careful in removing end plug; the spring behind end plug is under compression.
3. Remove the end plug and spring carefully followed by the other three pieces of the
valve assembly. Use of a small fl at end screwdriver may be needed to push out assembly
from under the trigger lever.
4. Place DC-111 silicone grease on all o-ring seals on valve assemby. Place into valve
housing.
5. Locate spring into hole of valve assembly and recess in the end cap.
6. Carefully screw end plug into place using the 1/4” spanner bit.
To Next Page
Loading...
