14
player), the volume bypass switch should be set to ON. Then the speaker will turn on when
a source is connected. If no signal is provided to the speaker for a period longer than 10
minutes, the speaker will automatically go into standby.
Specifications
Amplifier
Input Sensitivity/impedance: 500mV/47Kohm
Line output level/impedance: up to 500mV/2.2Kohm
Rated Output Power(RMS): 20W (4Ω Load Resistance, THD 0.7%)
Signal noise ratio: min. 90dB
Frequency Response: 40Hz~20KHz(+3/-1dB)
Power supply voltage: 220-240VAC~50/60Hz
Rear panel inputs: AC power input
3.5mm analog stereo jack input
Rear panel outputs: 3.5mm analog stereo jack output
Rear panel switches: Channel select switch
Volume bypass switch
Drivers
Woofer 5” fully shielded
Tweeter 25mm Neodynium soft dome
Cabinet
Weight 4,70kg
Dimensions (H x W x D) 230 x 145 x 200mm