13
BASIC OPERATION
Before plugging the power cord into the AC outlet, check to make sure all of the connections
have been properly completed. When they have been, carefully plug power cord into outlet.
Press the POWER button on the front panel to power the unit. The display panel will light.
When the unit is initially powered, a brief surge of electricity may cause interference with other
electronic equipment on the same circuit. If this occurs, connect the unit to an outlet on a different
circuit.
Selec t i n g So u n d So u r c e
1. Press any function button (DVD, TUNER,
TV
, AUX) to select the desired sound source.
The appropriate symbol will appear in the display.
2. When the TUNER button is pressed,
the last station listened to will play.
No t e:: The desired program source will not play
unless it and the selected signal button coincide
with the active program source signal input.
Vol u m e Con t r o l
The volume may be adjusted by either turning
the large volume knob on the front panel or
using the appropriate volume button on the
remote control.
Mu t e
Pressing the MUTE button temporarily mutes
every speaker. To resume audio, press MUTE
button again.
CONNECTING
POWER SUPPLY
POWER
HT-50 Home Theatre System
AUTO MEMO
PRE/TUN
DOWN
UP
INPUT
VOLUME
To Next Page
Loading...
Need help?
General
