PROBLEM CAUSE WHAT TO DO
No solution
is coming
out of
Cordless
system
Solution is
beading on
skin
Nozzle may be blocked.
Solution pick-up tube not fitted
correctly.
Solution cup is filled to low.
The solution dial is set too low.
Trigger is not being pulled.
Trigger is jamming.
Too much tanning solution has
been sprayed on the skin.
Dial is set to high and releasing
too much solution.
The spray application is too slow.
Spray warm water through the
applicator.
Remove the tube and re-fit.
Add more solution to the cup.
Increase setting on the solution
dial. Number 1 is the lowest, and
number 5 is the highest.
Pull the trigger to release the
solution.
Spray warm water through the
system while the solution dial is
set to “C” and pull the trigger
repetitively until it releases.
Dab area with a clean, dry towel
and re-spray lightly over the area
to blend tan.
Reduce setting on the dial.
Speed up the application, or
reduce the setting on the dial.
1 is the lowest, and 5 is the highest
setting.
TROUBLESHOOTING
www.tanningessentials.co
To Next Page
Loading...