SPRAY APPLICATOR MAINTENANCE GUIDE
STEP 1 Remove hose.
STEP 2 Unscrew solution cup and empty any excess solution. It is recommended
that this be done over a sink or a wet area.
STEP 3 Rinse the empty solution cup with warm water.
STEP 4 Refill the cup with warm water and screw back into the applicator, fix the
solution dial to ‘C’ and spray until the water runs clear. Rinse and repeat
if required
STEP 5 Empty solution cup and re-set the solution dial on the back of the gun
to the regular spray setting.
STEP 6 Wipe any excess water from the applicator with a cloth and leave out
to dry.
www.tanningessentials.co
Maintenance on the Applicator must be run at the end of each day the applicator is used.
To Next Page
Loading...
