12
13
CMS
13. DECLARATION OF CONFORMITY:
Details of the Apparatus: Tannoy Contractor Loudspeaker
Model Numbers: CMS 401e
CMS 401DCe
Applicable Standards: EN55103-1 1996 Emission
EN55103-2 1996 Immunity
Electrical Safety: Electrical Safety EN 60065: 1993
Signed:
Position: Engineering Director - Professional Products
Tannoy Professional
Date: 19/11/2015
For Music Group Innovation SC Ltd
11. PAINTING
If desired, the grille and baffle panel may be painted to match the surrounding décor.
Painting the baffle:
Carefully mask off the driver assembly using the paint-mask provided to ensure that the paint does not come into
contact with the cone and roll surround.
Painting the grille:
Carefully remove the acoustically transparent foam from the reverse side of the grille.
Paint the grille and then replace the foam.
Re-bond the foam to the grille over the entire area using a light spray-adhesive to avoid audible resonances.
Painting the trim:
The speaker must be aimed before painting.
The rubber trim should be left in place while painting.
Apply a vinyl emulsion to the trim.
12. WARRANTY
All Tannoy professional As part of the MUSIC Group, Tannoy is committed to providing the highest
quality products, service and user experience for our customers. One element of this commitment is our
after sales support which now incorporates our extended Limited Warranty. In the event of any concern
that is not addressed by this extended Limited Warranty we would ask you to contact us at
care@music-group.com
For full warranty details including the extended Limited Warranty, please visit
http://www.music-group.com/warranty.aspx and register your purchase online at www.music-group.com
or www.tannoy.com
The following apparatus is/are manufactured in China
for Music Group Innovation SC Ltd
The following apparatus is/are manufactured in China for Music
Group Innovation SC Ltd of Rosehall Industrial estate,
Coatbridge, Scotland, ML5 4TF and conform(s) to the protection
requirements of the European Electromagnetic Compatibility
Standards and Directives relevant to Domestic Electrical
Equipment. The apparatus is designed and constructed such
that electromagnetic disturbances generated do not exceed
levels allowing radio and telecommunications equipment and
other apparatus to operate as intended, and, the apparatus has
an adequate level of intrinsic immunity to electromagnetic
disturbance to enable operation as specified and intended. This
equipment conforms to the requirements of the EMC Directive
89/336/EEC, amended by 92/31/EEC and the requirements of
the Low Voltage Directive 73/23/EEC, amended by 93/68/EEC.
To Next Page
Loading...