Need help?Do you have a question about the Tannoy SFX 5.1 and is the answer not in the manual?
Performance| recommended amplifier power | 15 - 100 Watts |
|---|---|
| maximum sensitivity | 85dB |
| nominal impedance | 6 Ohms |
| frequency response | 140Hz - 78kHz |
Drivers| crossover frequency | 4.5kHz (mid to high) 140Hz (to subwoofer) |
|---|---|
| high frequency driver | 15mm (0.59”) titanium dome, neodymium magnet system |
| low frequency driver | 75mm (2.95”) paper cone |
Weight and Dimensions| satellite weight | 750gms (1.65lbs) |
|---|---|
| satellite dimensions | 140 x 97 x 95mm (5.51 x 3.82 x 3.74”) |
| centre weight | 1.5kg (3.3lbs) |
| centre dimensions | 120 x 230 x 95mm (4.72 x 9.06 x 3.74”) |
| finish | Black, White |
Performance| power output | 100 Watts |
|---|---|
| frequency response | 45Hz - 140Hz |
| driver size | 200mm (8.00”) paper cone |
Power Requirements| inputs | Twin line or speaker level |
|---|---|
| power requirements | 160VA max |
| fuse ratings | AC100-120V / 60Hz - Fuse: T1.6A L /250V, AC 220-240V / 50Hz - Fuse: T800mA L /250V |
Weight and Dimensions| weight | 9.0kg (20.0lbs) |
|---|---|
| dimensions | 345 x 250 x 370 mm (13.58 x 9.84 x 14.57”) |
| finish | Black, White |
Check that the voltage rating displayed on the rear panel is correct for your area before connecting.
A mains fuse is provided on the back of the subwoofer for safety and can be removed with a screwdriver.
Connect the subwoofer using RCA interconnects or Y-split connectors for line-level audio signals.
Connect the subwoofer using speaker cable outputs from the amplifier's speaker terminals.
Double-check polarity and avoid amplifier bridge mode when connecting speakers.
Ensure power is off, connect to mains, set volume, phase, crossover, and receiver settings.
Place subwoofer for optimum bass performance, adjusting volume for room acoustics.
Unit remains off until signal in AUTO mode, entering sleep after inactivity.
Verify voltage rating and fuse type match specifications for safe operation.
To Next Page
