EN
Specifications
Model
Operate Voltage
Power
Water Tank Volume
Working time
Max Humidity Increase
Ultrasonic Frequency
TT-AD002
DC 24V
13W max
300 ml / 10 oz
8 hours max
About 30 ~ 70 ml / 1 ~ 2 oz per hour
2.4 MHz
How to Use
Caution
1) Please add water to the tank first, then pour essential oils up to the
marking on the tube or until dispensing starts. If there's no
fragrance, the water-oil balance may be off. Please add enough
essential oil as instructed then.
2) If you are using a glass essential oil tube, please handle with care
to avoid breakage.
3) It is recommended to use purified or distilled water.
Note:
Never pour essential oils into the tube when there is no water inside
the tank.
Operations and Functions
Connect to a power source. Once connected the diffuser will enter
standby mode. Please make sure there is enough water inside the tank.
Power On
Press the Mist Button to turn on the unit.
Change the Mist Output
Press and hold the Mist Button to enter high mist with one beep and low
mist with two beeps.
Change the Light Color
1. Press the Light Button once to automatically cycle through different
colors.
2. Press again to stay on the current color. Keep pressing to cycle through
all the colors. When the cycle is done, press one more time to turn off
the light.
3. Or press and hold the Light Button for 2-3 seconds to turn off the light.
Set the Timer
When the mist is on, press the Mist Button to set 1 / 3 / 6 hour timer or
turn off the timer. The timer indicator will light up accordingly. When the
ON indicator is on, the timer is off.
Package Contents
· 1 x TaoTronics Aroma Diffuser (Model: TT-AD002)
· 1 x Power Adapter
· 1 x Cup
· 1 x User Guide
Add and Drain Water
1. Remove the tank cover, add water into the tank no higher than the
max water level line. Drizzle a few drops of essential oil into the
tube until dispensing starts. Put the tank cover back on.
2. Clean the water tank with the included brush when grime builds up.
Power Off
When the timer is off, press the Mist Button once to turn off the unit.
Cleaning the Water Tank
· Unplug the power cord and remove the cover.
· Drain any reaming water from the tank.
· Add some warm water into the tank and mix with mild detergent, wash
with a cleaning cloth.
02
01
To Next Page
Loading...
Need help?
General
