The troubleshooting guide addresses the most common problems.
If problems persist, feel free to contact the Customer Support at
support@taotronics.com
Product Issues
The processor doesn’t start.
· Ensure all accessories are properly assembled.
NEVER try to install the bowl with handle on
the left.
There is a safety interlock to prevent the motor
from starting if not properly assembled.
· If the processor still cannot start, check the
power cord and outlet.
The processor shuts off
during operation.
· The lid may have become unlocked; check to
make sure it is securely in position.
· The processing bowl or the blender might loose
during processing, reattach the bowl or the
blender and start again.
· Long time operation may trigger the over-heat
protection. We suggest you to use the machine
2 minutes per time (blender function for 1 minute
per time). Cool it down before using again if
over-heat protection is triggered.
The processor emits dark
smoke or pungent smell.
This happens when the motor gets overheated,
turn it off and unplug from the outlet. Wait for at
least 30 minutes and plug again before using
again.
Difficult to assemble the blade
and the drive shaft.
Carefully install the blade over the drive shaft.
Ensure that the UP marking is facing upwards
when fitting the blade onto the drive shaft.
Slightly rotate the blade to align with the grooves
on the drive shaft. Once aligned, the blade
will lower down, almost touching the bottom of
the processing bowl.
Accessory is broken or missing. Contact our Customer Support for guidance or
replacement.
18
Food Processor
19
Food Processor
To Next Page
Loading...
Need help?
General