You can find below some key recommendations to get the maximum performance of your amplifier:
3 - It is compulsory to install fuses to protect against overloading. The fuse or circuit breaker must be
installed as close as possible to the battery and sized up according to the amplifier;
1- Read this instruction manual carefully before carrying out any connection;
2 - Check carefully the polarity of power supply wiring (battery's positive and negative terminals)
loudspeakers and the minimum speaker impedance;
4 - The gauge of power supply wiring is extremely important both to reach the desired amplifier power
and to the amplifier's safety. Use the wire gauge recommended in this manual (page 11). Using wire
gauges below the specified value will result in power loss and overheating of cables. It is important that
the power supply cables are the shortest lenght as possible;
6 - In order to avoid interferences, the signal cable (RCA) must be installed away from the vehicle’s wire
harness or from any other power supply cable;
7 - The amplifier must be installed by a qualified professional.
Any connection to the amplifier input or output must be carried out when amplifier is off;
5 - The amplifier must be installed in a firm and ventilated area;
Taramps reserves the right to modify the contents of this document at any time without prior notice and does
not have the obligation to apply the changes in units which were previously produced.
For questions, please call +55 (18) 3266-4050, e-mail support@taramps.com.br or visit
www.taramps.com.br.
It was developed in a modern laboratory and with the latest technology.
Congratulations on your purchase of a Taramps product.
This manual covers all features, operations and instructions to solve any doubt that may arise during the
installation. Please take some time to read it carefully in order to ensure the proper installation and the
use of all benefits that this product can offer.
Power connector for cables up to 1/0 AWG: Allows the use of power cables with larger gauge (up to
50mm²) for higher performance;
SMART LEDS: LEDs output signal level indicator on top of product;
RAMP audio initialization: After turning on the amplifier, audio is released gradually (ramp).
AUTO-Restart Protections: The amplifier automatically restarts after a protection event;
Multi-impedance: Featuring new control technology and new functions, the SMART 3 brings 3000W
RMS rated power in the range of 1 to 2 Ohms: (1 - 1.33 - 1.5 - 1.67 and 2 Ohms with same power);
Dual RCA IN / OUT Input: RCA connector with input and output function, eliminates the needing of “Y”
cables for send the same unput signal to another amplifier;
RCA input for up to 4V RMS: Input gain adjustment that allows head units up to 4VRMS output level;
08
Key recommendations
Introduction
Smart Line Presentation
ENGLISH
To Next Page
Loading...