Tarantula RS.1 User Manual

FCC ID NOTICE
This device complies with Part 15 of the FCC rules. Operation is s
ubject to the following conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including inte
rference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part responsible for compliance void the user’s authority to operate
www.security.soundstream.com
this device.
RS.1
REMOTE VEHICLE STARTER
INSTALLATION GUIDE
REV.5

Tarantula RS.1 Specifications

General

Remote Range	Up to 3000 feet
Number of Buttons on Remote	5
Range	Up to 3000 feet
Remote Start	Yes
Keyless Entry	Yes
Operating Voltage	12V
Confirmation	Audible and visual
Remote Start Duration	15 minutes
Safety Features	Hood pin switch
Compatibility	Most vehicles
Smartphone Control	Optional
Installation Required	Yes

Summary

Wire Diagram

Wire Diagram

Bypass Module Data Communication Port

Details the data communication port for bypass modules.

Selectable Park Light Output

Explains how to configure park light output polarity.

Tach Learn

Auto Tach/ Tachless Learning

Explains automatic tach learning methods.

Hybrid Mode's

Details different hybrid modes for starting.

Low Idle Learning

Describes the process for learning low idle RPM.

Wire Description

6-Pin Connector

Details the pinout and function of the 6-pin connector.

2-Pin Connector

Details the pinout and function of the 2-pin connector.

3 Pin Door Lock Connector

Details the pinout for door lock connections.

3 Pin Bypass Module Connector

Details the pinout for bypass module connections.

Wire Description

9-Pin Connector

Details the pinout and function of the 9-pin connector.

Transmitter Programming

Programming Additional Transmitters

Explains how to program multiple remote transmitters.

Entering Remote Program Mode

Step-by-step guide to entering programming mode.

Programming

Entering Program Mode

Steps to enter the system's programming mode.

System Reset

Procedure to reset the system to factory defaults.

Program Menu 1 & 2

Program Mode 1

Settings and options for Program Mode 1.

Program Mode 2

Settings and options for Program Mode 2.

Program Menu 3 & 4

Program Mode 3

Settings and options for Program Mode 3.

Program Mode 4

Settings and options for Program Mode 4.

Diagnostics

Diagnostics Chart

Table listing park light flashes and diagnostic codes.

To Enter Diagnostic Memory

Steps to access and view diagnostic codes.

Installation Notes

2 Button Remote

Specific notes for 2-button remote operation and programming.

Installer Notes

General notes for installers.

Relay Diagrams

Door Lock Diagrams

Diagrams illustrating door lock wiring configurations.

Positive Type Using Inverter

Specific wiring for positive type systems with an inverter.

Relay Diagrams

Door Lock Diagrams

More diagrams for door lock wiring.

Negative One Wire Door Locks

Wiring for negative one-wire door locks.

Reverse Polarity Door Lock System

Wiring for reverse polarity door lock systems.

After-Market Door Lock Actuators

Wiring for aftermarket door lock actuators.