Targa ENVIRO VAC - Page 6

6
ENGLISH
99.973%
82%
80%
HEPA Cartridge Filter
Vacuum Filter
Clean Air Filter Bag
Filtration Systems
Filter Congurations and Maintenance Tips
Conguration Installation Applications Tips
“Clean Air “ Filtration
(Grey Targa Filter)
1. Remove vacuum head from tank.
2. Place Targa lter in tank.
3. Replace vacuum head on tank with the airow
indicator light centered over tank inlet. Align
clamps on the side of tank with tabs on head
and lock clamps.
General dry vacuuming.
(i.e. schools, hotels, oces, etc.)
• To maximize lter life, maintain air quality
and performance, clean lter with soft brush,
shake, or wash in lukewarm water.
• Inspect lter for signs of wear and replace if
necessary.
• For best performance, use with a paper dust
bag installed.
Superior “Clean Air” Filtration
(Grey Targa Filter + Paper Dust
Bag)
1. Remove vacuum head from tank.
2. Unfold dust bag, gently seperate walls of bag,
insert into tank (before placing Targa lter in
place).
3. Slide rubberized bag collar over inlet nozzle.
Ensure collar face is against tank wall.
General dry vacuuming with the convenience
of a bag. (i.e. schools, hotels, oces, etc.)
Excellent for ne dust applications where
blinding of lter is a problem.
(i.e. chalk dust, dry wall dust, lampback, silica
dust, etc.)
• Ensurecollaris on inlet asfaraspossible(if
not, bag may come o).
• Sides of bag should be seperated after
installed in tank to maximize entire bag
volume.
• Grey Targa lter must be in place before
operation.
Optimum “Clean Air” Filtration
(Targa Filter + Paper Dust Bag +
HEPA lter)
1. Remove vacuum head from tank, setting the
head on the side.
2. Place clamp on outer ring of HEPA (do not
tighten until lter is on black oat cage).
Ultra high ltration vacuuming where air
quality is crucial.
(i.e. hospitals, computer areas, areas where
asthmatics and allergy suerers live and work.)
• To maximize lter life, maintain air quality
and peak performance, the HEPA lter
should only be cleaned with a soft brush or
blown clean with compressed air.
• Never wash or expose HEPA lter to water as
this will damage lter material.
• Inspect lter for signs of wear and replace if
necessary.
• Always use with paper dust bag and Targa
lter.
Wet Filtration
(Targa 990 and Targa XL)
WARNING! REMOVE ALL OTHER
FILTERS BEFORE INSTALLING
WET FILTER
1. Remove vacuum head from tank.
2. Remove any other lters.
3. Empty out contents in vacuum tank (rinse out
with water if possible).
4. Place wet lter in tank ensuring black gasket is
free of dirt and sitting at on tank rim.
5. Replace head and lock clamps.
For removal of liquids from carpets and hard
oors. Ideal when picking up liquids after
stripping and rinsing oors and for removal of
slush from entrance walk-o mats in winter.
• After vacuuming liquids, clean by vacuuming
a small amount of clean water. Allow to dry in
a ventilated area.
• To minimize foam build-up, use Dustbane’s
De-Foam in tank.
• For ease of emptying, ll tank to no more
than 3/4 full.
• Do not use for dry application as this will
result in damage to the motor.