7
installing L-bracket
There are several "key points" to L-
bracket installation. Please
review the drawings and
comments at right as well as
the assembly steps provided.
All units must be fastened to the wall.
Always mount L-bracket to a wall-
stud.
The L-bracket is intended to be
installed on panel B.
Install the screw hole end of L-bracket against
at least one wall stud; horizontal adjustable end
against unit. L-bracket must be mounted no more
than 1 1/2 inches from edge of panel.
panel A
panel B
Secure L-bracket on the inside of panel B. See step 5
for detailed installation instructions.
wall
stud
Serious or fatal crushing injuries can occur
from furniture tip-over. To help prevent
tip-over:
- Install tip-over restraint provided.
- Unless specifically designed to accommodate,
do not set TVs or other heavy objects on top of
this product.
- Never allow children to climb or hang on
drawers, doors, or shelves.
- Place heavy items on lower shelves and as far
back as possible.
Use of tip-over restraints may only reduce,
but not eliminate, the risk of tip-over.
This is a permanent label. Do not attempt to remove.
WARNING
To Next Page
Loading...
