Need help?Do you have a question about the Tartan Ten and is the answer not in the manual?
General| Beam | 10.83' |
|---|---|
| Displacement | 10500 lbs |
| Ballast | 4800 lbs |
| Sail Area | 510 sq ft |
| Designer | S&S |
| Length Overall | 33.0 ft |
| Engine | Yanmar Diesel |
Checks before launching the boat: engine, drain plugs, propeller shaft, battery, and oil levels.
Procedures for lifting the hull and checks immediately after launching, including bilge and engine systems.
Installation steps for backstay, shrouds, headstay, and spreaders before stepping the mast.
Information on the Farymann diesel engine, including starting, stopping, and oil checks.
Details on interior cushions, trimming ballast, and their properties.
Information on running backstays, forward air vents, bilge pump, and water tank systems.
Guidelines for general maintenance, fiberglass, gel coat, and finishes care.
Instructions for maintaining exterior teak, interior teak, and boot top paint.
Detailed list of running rigging items, including lengths, diameters, and attachments.
Detailed list of spinnaker gear items, including lengths, diameters, and attachments.
Procedures for managing halyards and stepping the mast spar.
Methods for tuning the rig and installing chain plate covers.
Details on backstay tensioner, main sheet, traveller tag lines, and boom vang.
Instructions for jiffy reefing, sheets, foreguy, spinnaker sheets, and twing lines.
Operation and details of bilge pump, water tank, and head systems.
Information on hull-deck joint, dodger installation, and fresh water system.
Details on bottom paint, fiberglass interior maintenance, and speedometer installation.
Information on plastic cleats, metal cradle, and the 12V electrical system.
Instructions for draft marks and details on the exhaust system.
Safety information regarding lifelines, keel joint, and lightning protection.
Diagram and notes for headstay link plate installation.
Diagram and notes for backstay link plate installation.
Guidelines for general maintenance, fiberglass, gel coat, and finishes.
Instructions for maintaining exterior teak, interior teak, and boot top paint.
Maintenance advice for sails, lines, spars, rigging, and the engine.
Information on mainsail hoist setup and feeder requirements.
Details on reefing cringles, sail attachment, and mainsail groove sizes.
To Next Page