RC-SS150
2
TASCAM
RC-SS150
7. Select the firmware update to use.
The screen shown below will appear.
The number of the current version is shown on the
left and the update version is shown on the right.
The screen shown below will appear on the RC-SS150.
NOTE
The screen shown above is an example. The actual ap-
pearance will differ.
8. Press the MULTI JOG dial on the SS-R250N/SS-
CDR250N to start updating.
CAUTION
i
Be careful not to let the power be interrupted during
the update.
i
Do not load or remove media during the update.
i
If the power is interrupted or media is loaded or re-
moved during the update, the unit might become un-
startable.
9. When the update completes, the following message
will appear.
SS-R250N/SS-CDR250N screen
RC-SS150 screen
10. When the unit automatically turns off after the mes-
sage appears, turn it on again.
11. Confirm that the latest firmware is being used. This
completes the update procedure.
12. Delete the firmware update file from the medium.
To Previous Page
Loading...
