TROUBLE SHOOTING
UNIT WILL NOT BLOW OR VACUUM
PROBLEM CORRECTIVE ACTION
Bag full Empty bag.
Blocked tube Clear the blockage as described on page 10.
Blocked impeller Clear the blockage as described on page 10.
Damaged impeller Take the unit to an authorized service dealer.
Dirty bag Clean the bag.
Torn bag Replace the bag.
Bag unzipped Zip up the bag.
Unit unplugged Plug into an outlet or an extension cord.
UNIT WILL NOT START
PROBLEM CORRECTIVE ACTION
Unit is unplugged. Check cord to make sure it is plugged into an
electrical outlet.
Power/speed switch is in the OFF position. Slide switch to high or low.
Defective power switch. Return to place of purchase or return the unit to
a repair center.
Vac tubes are not correctly installed. Check vac tubes to ensure that they are
allowing the switch to be engaged when
correctly installed.
Intake gate/cover is not closed. Ensure that gate/cover is fully closed and
locked.
- 13 -
To Next Page
Loading...