Task Force 26053 - Assembly Instructions; Assembling and Attaching Rear Grass Bag

Assembling and attaching the rear bag: (Fig. 3, 4, 5 and 6)
1. Layout all components in the packaging.
2. Open all hook and loop seams on the grass bag and place the frame into position and fold hook and loop
seams back together. (Fig
. 3)
ASSEMBLY INSTRUCTIONS
6
Fig. 3 Fig. 4
Fig. 6
3. Remove pre-installed wing nuts (1). Install center bar (2) over top of threading (3) and reinstall the wing nuts (1) securing
the center bar in place. (Fig. 4)
5. Place locking strap (5) from the rear bar of the bag to the center bar of the middle handle. Adjust strap for
proper height so the bag does not rub the ground while mowing or transporting (Fig.6).
Fig. 5
1
2
3
3
4 . Place hook of rear attachment hook (4) to the frame of the bag corners (Fig. 5).
4
4
5