19
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 I15 tr sv pt pl no nl it fr fi es en de da cz
Overview
1 Push handle foldable
2 Handle for winding the power cord
3 Cover (removable)
4 Spray water hose connection
5 Rotary button for water volume regulation
6 Locking button for suction hose
7 Suction hose connection
8 Dirt sieve
9 Float and fastening button
10 Float protection
11 Return hose fo excess water
12 Output line for pump
13 Rocker switch for vacuum
14 Rocker switch for pump
15 Unlocking button for push handle
16 Drain hose for soiled solution
17 Recovery tank
18 Solution tank
19 Running wheel
20 Steering castor
21 Push-in filter with sealing cover for fresh water
22 Cover for the solution tank
Preparation for operation/Operation
Preparing the carpet
Spray the 10% solution over all the surface with the aid of the spray device and
the spray lance, and allow to work in for 10-15 minutes.
Filling the tank
Only use chemical products recommended by the manufacturer.
The correct dosage is recommended on the product's packaging and on the
"TASKI Product Information Sheet".
Beginning work
Vacuum off the carpet before working with the carpet-cleaning
machine.
In the case of visible stains, treat the carpet with a TASKI stain
remover.Your TASKI partner can help you with this.
Caution:
The machine can be damaged or destroyed by the use of other
products (e.g. products containing chlorine).
Maximum permissible water temperature 40 °C/104 °F.
• Fold out the push handle until it locks into place
by the retaining bolts.
• Screw on the drain hose and clamp it into the
hose retainer.
• Fit the soiled water cover.
• Connect the two tank cover connection hoses to
the basic machine.
• Connect the suction hose, spray water hose
and the mains power connection cord.
Basic cleaning, rinsing the carpet
• Press both switches.
• Set the water volume regulation to maximum.
• Start in the remotest corner.
• Press the action grip for the spray valve. The
water is sprayed onto the carpet and is then
vacuumed up again.
• Pull the extension pipe towards you. The more
slowly you pull, the more thorough will be the
cleaning.
• Set the required water quantity corresponding
to the carpet using the rotary switch for the
water quantity regulation.
• Release the action lever for the spray valve and
continue vacuuming for a further 10 cm.
• Lift the squeegee.
• Start a new run. The squeegee must thereby
overlap slightly with the previous run.
Continue working according to this system.
Caution:
To avoid water splashes:
Before disconnecting the spray hose, always:
- Switch the pump switch to OFF.
- Operate the manual valve once again to reduce the pressure in
the spray hose.
Pushing:
Push the machine by the handle.
In case of small irregulartities or steps:
Tilt the machine by pushing the handle until the wheels have
overcome the obstacle, then lower the machine again.
In case of higher steps:
Tilt the machine and pull the machine backwards over the step.
To Next Page
Loading...
