71
-
-
-
Emptying at high altitudes:
• Press the Brush drive ON/OFF but-
ton.
The cleaning solution supply is
stopped.
• Continue to drive a few meters.
Very important for TASKI contact pads!
• Press the Brush drive ON/OFF but-
ton.
The display lights up and the brush
unit is stopped and lifted.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Press the Suction unit ON/OFF but-
ton.
The display lights up and the squee-
gee is automatically lifted.
The suction engine continues run-
ning for 15 seconds to prevent drip-
ping.
• Press the Program ON/OFF button.
The cleaning solution supply is
stopped.
• The brush unit is stopped and lifted.
• After 30 seconds, the suction nozzle / squeegee is lifted.
• The suction motor is still on for 15 seconds until it is auto-
matically switched off.
• The machine must be switched off.
• Remove both suction hoses from the connectors and con-
nect them to the hose holder.
• Compress the position locks.
The suction nozzle is released and
can be removed from the suction
nozzle holder.
• Clean the suction nozzle under running water using a
brush.
• After thorough cleaning, hang the squeegee on the squee-
gee suspension on the rear of the machine.
• Remove the drain water hose from the holder.
• Put the drain hose into the drainage.
• Press the crushing point (1) of the drain hose.
• Pull the lid off the drain hose and
drain the recovery tank.
• Lift the fresh water tank (Flextank), put it into the recovery
tank at the lowest point and discharge it.
• Remove the empty fresh water tank (Flextank) from the re-
covery tank and thoroughly rinse it with clean water.
• Thoroughly rinse the recovery tank with clean water.
• Remove the solids filter (yellow) and
empty it.
• Rinse the filter thoroughly under run-
ning water.
• Remove the suction filter (yellow)
and wipe off dirt using a cloth or a soft
brush.
• Take out the intake filter and remove
the dirt with a cloth or a soft brush.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hose into the holder.
• The machine must be switched on.
• Direct the drain hose to a drain or into a bucket.
• Press the button at the drain water pump.
To Next Page
Loading...
