17
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 I15 tr sl pt pl no nl it fr fi es en de da cz
Storage / parking of machine (machine is idle)
Never store the machine with the tank cap closed.
This allows the tank to dry out. As a result, the formation of mould and
unpleasant smells can be reduced.
Service, maintenance and care
Maintenance of the machine is a pre-condition for trouble-free running and an
extended service life.
Service intervals
TASKI machines are built to the highest quality standards. This is supported by
internationally recognised quality control procedures. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.
Malfunctions
Technical data
Accessories
Transport
Ensure that the unit is securely fastened within the transportation vehicle.
Disposal
When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations. Your
TASKI partner can assist you with the proper disposal on request.
Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
Symbols:
◊ = After use, ◊◊ = Every week, ◊◊◊ = Every month,
⊗ = Service light
Activity ◊◊◊◊◊◊⊗ page
Drain and clean the tank
16
Clean the filter and sinter bushing
16
Wipe down the machine with a damp cloth
16
• In order to maintain operational reliability and availability for use, a service
must be carried out after 250 working hours or at least once a year.
Shorter intervals may be necessary under rough or extreme working
conditions and/or insufficient maintenance.
Malfunction Possible causes Troubleshooting page
Machine does not
run
Not turned on
• Turn on
16
Power supply cord not
properly plugged into
the mains socket
• Check
Power supply cord not
properly plugged into
ergodisc
• Check
Power supply cord
defect
• Call for technical
assistence
Dosing control unit
defect
• Call for technical
assistence
Motor does not turn
• Call for technical
assistence
No foam released
Tank is empty
• Check the tank, and
refill if necessary
15
Tank cap not sealed
properly
• Check
Filter blocked • Clean filter 16
Sinter bushing
blocked
• Clean sinter bushing
16
Name/model FG 2 FG 2C
Rated voltage 230-240V 120V ac
Frequency 50 60 Hz
Rated power 120 110 W
Assessed sound level LPA according
to EN 60704-1
62 62 dB(A)
Splash water protection IPX4 IPX4
Electrical protection class II II
Article FG 2
8505010 Hand shampooing set X
To Previous Page
Loading...
Need help?
General