24
Inserting the double-filter paper bag
Replacing the motor protection filter, exhaust air filter suction unit,
exhaust air filter electrical suction brush
(1) Motor protection filter, (2) exhaust air filter suction unit, (3) exhaust air filter
electrical suction brush
Cleaning the roller brush
Cleaning the machine
After every third double-filter paper bag replacement, the motor
protection filter must be cleaned or replaced (Cleaning/Replacing
the motor protection filter see page 24).
• Pushing the new double-filter paper bag
upwards.
• Press the red unlocking device and slowly push
the double-filter paper bag upwards.
• Release the locking device.
The double-filter paper bag is clamped at the
edges.
• Close the cover of the suction unit.
The cover of the suction unit must lock into
place.
Check the filter regularly for soiling, and replace when necessary.
Caution:
Never operate the machine without the filter!
Caution:
Danger of injury due to sharp objects.
Wear gloves for your own protetction!
Check the roller brush for wear after every use.
Bristles that are too short or a damaged roller brush could cause
damage to the floor covering!
• Push the side cover away from the brush
housing.
• Using a screwdriver, slowly raise the roller
holder.
• Slowly pull out the roller brush.
• Remove the roller holder from the roller brush.
The roller holder will be re-used.
Before carrying out the installation, check the length of the bristles
and replace the roller brush if necessary.
Bristles that are too short or a damaged roller brush could cause
damage to the floor covering!
• Clean the roller brush.
• Push the roller brush into the brush housing with
the hexagonal opening at the front.
The white mark must be aligned to a straight
surface (see picture).
• Press in the roller holder until the end-stop.
• Push in the side cover.
Caution:
Never clean the machine with high water pressure or a water
hose.
Any water that finds its way into the machine could lead to serious
damage to the electrical or mechanical components, and could
thereby result in injuries to persons.
• Pull the power supply cord out of the mains socket.
• Wipe down the machine with a damp cloth.
To Next Page
Loading...
