Taski Swingo 150 Translation Of The Original Instructions Of Use

33
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 tr sv sl pt pl no nl it fr fi es en de da cz
Cleaning the transport wheels
Cleaning the machine
Service, maintenance and care
The machine's maintenance is a pre-condition for trouble-free running and a
long life.
Service intervals
TASKI machines are built to the highest quality standards. This is supported by
internationally recognised quality control procedures. Electrical and mechanical
parts are subject to wear or aging if used for long periods of time.
Service centre
Should you contact us due to a malfunction or for placing an order, please
always state the type, description and the serial number of your machine.
You can find this information on the name plate of your machine, and the
address of your nearest TASKI partner can be found on the last page of this
manual.
Transport
Make sure that the machine is securely fastened within the transportation
vehicle.
Disposal
When it has reached the end of its operational life, the machine and its
accessories must be disposed of according to the national regulations.
Malfunctions
Technical data
Accessories
• Before and after using the machine, always
clean the runnung surfaces of the transport
wheels with a damp cloth.
The transport wheels can become soiled by
transportation over asphalt.
Caution:
Never clean the machine with high water pressure or a water
hose.
Any water that penetrates into the machine can lead to serious
damage to the mechanical or electrical components and can
thereby also lead to injury to persons.
• Pull the power supply cord out of the mains socket.
• Wipe down the machine with a damp cloth.
Caution:
Only TASKI branded spare parts must be used, otherwise
warranties and liabilities will be omitted!
Symbols:
◊ = after use, ◊◊ = every week, ◊◊◊ = every month
Activity ◊◊◊◊◊◊page
Wash out the squeegee
32
Clean the brush roller
32
Periodically check the length of the bristles.
Replace the brush roller 32
Suction channel service cover
29
Clean/replace the motor protection filter
31
Wash out the sponge filter
32
Pump protection filter
32
Clean the machine with a damp cloth
33
Clean the transport wheels
33
• To maintain functional safety and operational readiness, a service must be
carried out at least once a year.
Under rough or extreme working conditions and / or insufficient
maintenance, shorter intervals may be necessary.
Malfunction Possible causes Troubleshooting page
Machine does not
run
Not turned on • Turn on 30
Power supply cord not
properly plugged into
the mains socket
• Check
Power supply cord
defect
• Call for technical
assistance
Motor defect
• Call for technical
assistance
Main switch defect
• Call for technical
assistance
Brush roller not
turning
Machine not in the
working position
• Place the machine in
the working position
30
Motor runs but not
tool
• Drive defective
• Call for technical
assistance
Poor vacuum
performance
Motor protection filter
soiled
• Clean or replace the
motor protection filter.
31
Suction hose not
connected
• Check
Name swingo 150
type CO150.5 CO150.5C
Rated voltage 220-240V 120V AC
Frequency 50-60 60 Hz
Rated power 1100 1100 W
Machine weight 12.7 12.7 kg
Dimensions (L x B x H) (ready for
operation)
43x38x112 43x38x112 cm
A-weighted emission sound pressure
level EN 60704-1
74 74 dB(A)
Electrical protection class II II
Article swingo 150
7516236 Brush roller medium black X
7516237 Brush roller hard red X
7516546 Squeegee set X

Taski Swingo 150 Specifications

General

Brand	Taski
Model	Swingo 150
Category	Floor Machine
Language	English