11
I25 I24 I23 I22 I21 I20 I19 I18 I17 I16 I15 I14 I13 I12 I11 I10 I9 I8 tr no it fr es en de
Preparation for operation/Operation
Attaching tools
Check:
• that the tools are not below the red marking and that the bristle length is not
less than 1 cm.
• the pad for wear before using.
Attach squeegee
Filling water
Dosage:
Only use chemical products recommended by the manufacturer.
Dosing examples (The concentration is product dependent)
Beginning work
Cleaning method
Direct method:
Scrubbing and vacuuming in one pass.
Indirect working method:
Apply the cleaning solution (only scrubbing), afterwards scrubbing and
vacuuming.
The cleaning methods are described in detail in the ”Method Card”. You can
obtain this from your TASKI partner.
Refilling the solution tank
When the tools are no longer sufficiently supplied with the solution, the tank
containing the solution is empty.
• Switch the machine off and pull the power supply cord out of the mains
socket.
Working with worn out, damaged and or wrong tools, could result
in possible damage to floors or their protective layers.
• Position the tool below the brush unit.
• Plug the power supply cord into the mains socket.
• Switch the machine on (main switch and mains
socket).
The main switch lights up.
• Unlatch the foot lever and slowly lower the tool.
• Briefly pull the brush drive bar.
By doing this the tool will be centered and coupled.
• Switch the machine off and pull the power supply cord out of the mains
socket.
• Raise the squeegee and loosen the fixing
screws on the squeegee.
The squeegee support wheel must be in the
direction of movement.
• Assemble the squeegee and tighten the fixation
knobs.
• Attach the suction hose to the squeegee.
Caution:
Maximum permissible water temperature 60 C/140 °F.
• Switch the machine off.
• Lift the tank lid.
• Fill water into the solution tank.
Maximum permissible filling level (Page 10).
Caution:
Wear protective gloves, goggles and the corresponding
(protective) work clothing when handling chemical products!
Caution:
Using other chemicals (e.g. chemicals containing solvents,
chlorine, hydrochloric acid and hydrofluoric acid) can damage or
destroy the machine.
Instructions on the product’s
packaging
Tank capacity The volume per
tank filling
0.25% 25ml to 10l water 20l 50ml = 0,05l
max.60˚C
max.140˚F
0.5% 50ml to 10l water 20l 100ml = 0,1l
• Add the product measured with the dosing aid to the water in the solution
tank.
Caution:
Always wear non-slip shoes and appropriate work clothing while
working with this machine!
• Lower the squeegee.
• Unlatch the foot lever and slowly lower the tool.
• Plug the power supply cord into the mains
socket.
• Switch the machine on (main switch and mains
socket).
The main switch lights up.
• First press the cleaning solution switch, and
then the suction unit switch.
The indicators light up briefly.
• Adjust the volume of the cleaning solution.
• Pull the operating lever.
By doing this the tool is activated.
Under certain circumstances, the driving of the machine can be
impaired by a special combination of surface/soiling and cleaning
product.
This effect can be reduced by special wheel options.
Caution:
Do not clean without solution, as it could cause floor damage.
• Stop cleaning.
• Refill the tank, see Page 11.
Instructions on the product’s
packaging
Tank capacity The volume per
tank filling
To Next Page
Loading...
Need help?
General