be reduced.
- Washing the air lters by submerging them
- Carefully in warm water with a neutral deter-
gent, rinse them off and let them dry completely
in a shady place.
- Install the lters carefully after having them
cleaned.
AFTER PERIODIC MAINTENANCE:
- Switch off the appliance and remove the plug.
- Separate the exhaust pipe from the air and
store it carefully.
- Put the appliance in a dry place.
- Remove the batteries from the remote control
and store them carefully.
ANOMALIES AND REPAIR
- In the event of a fault, take the appliance to an
authorized service center. Do not attempt to dis-
assemble or repair it as there may be danger.
- Any person who is involved with working on or
breaking into a refrigerant circuit should hold
a current valid certicate from an industry-ac-
credited assessment authority, which authorizes
their competence to handle refrigerants safely
in accordance with an industry recognized
assessment specication.
- Servicing shall only be performed as recom-
mended by the equipment manufacturer. Main-
tenance and repair requiring the assistance
of other skilled personnel shall be carried out
under the supervision of the person competent
in the use of ammable refrigerants.
- If any fault is detected, refer to the following
table:
Problem Causes Solutions
Product is not working No llega corriente.
Indicador de llenado de agua
iluminado
Switch on device
Empty water tank
Start device after empty water tank
Seems device is not
working
Windows or doors are open
Dirty lter
Air inlet or outlet are block
Room temperature is lower
than the programated
Close courtains
Close windows
Clean or change air lter
Clean container
Change temperature setting
Devide noise too loud Device is not in a at surface Change device in a at surface
Compressor is not
working
Overheat protection is activa-
ted
Switch on device after 3 minutes, when
temperature is lower
Detection codes Meaning
E0: Temperature sensor problem
E2/E4: Water tank full
The appliance contains ammable
refrigerant.
FOR EU VERSIONS OF THE PRODUCT AND /
OR IF APPLICABLE IN YOUR COUNTRY:
ECOLOGY AND RECYCLABILITY OF THE
PRODUCT
- The materials that constitute the packaging of
this apparatus, are integrated in a system of
collection, classication and recycling of the
same. If you want to dispose of them, you can
use the appropriate public containers for each
type of material.
- The product is exempt from concentrations of
substances which may be considered harmful
to the environment.
This symbol means that if you want to
dispose of the product, after the end of its
life, you must deposit it by the appropri-
ate means at the disposal of an autho-
rized waste manager for the selective
collection of Waste Electrical and
Electronic Equipment (WEEE).