English
Espresso coffee-maker
Ancona
Dear customer,
Many thanks for choosing to purchase
a TAURUS brand product.
Thanks to its technology, design and
operation and the fact that it exceeds
the strictest quality standards, a fully
satisfactory use and long product life
can be assured.
Description
A Steam regulator
B Water tank
C Cup warmer
D Drip tray
E Tray grill
F Vaporiser
G Supply cable
H On/off switch
I Filter holder
J Measuring spoon
K Filter for ground coffee
L Filter for single measure
M “Machine on” pilot light
N “Steam ready” pilot light
O “Machine ready coffee/water pilot
light
P coffee release button
Q steam release button
R Water filter
Safety advice and warnings
Read these instructions carefully be-
fore switching on the appliance and
keep them for future reference. Failu-
re to follow and observe these instruc-
tions may result in an accident.
Use or working environment:
- The appliance should be used and
kept over a flat and stable surface.
Electric safety:
- Do not use the appliance if the
cable or plug is damaged.
- Ensure that the voltage indicated
on the nameplate matches the
mains voltage before plugging in the
appliance.
- Connect the appliance to a base
with an earth socket withstanding a
minimum of 10 amperes.
- The appliance’s plug must fit into
the mains socket properly.
- If any of the appliance casings
breaks, immediately disconnect the
appliance from the mains to prevent
the possibility of an electric shock.
- Do not use the appliance if it has
fallen on the floor, if there are visible
signs of damage or if it has a leak.
- Never use the electric wire to lift
up, carry or unplug the appliance.
Do not roll up the electrical connec-
tion wire close to the appliance.
- Do not allow the connection cable to
hang or to come into contact with the
appliance’s hot surfaces.
- Check the condition of the electrical
connection cable. Damaged or
tangled cables increase the risk of
electric shock.
- Do not touch the plug with wet
hands.
Use and care:
- Do not use the appliance if the
accessories or parts are not fastened
Manual Ancona.indb 18 17/05/11 17:43
To Next Page
Loading...
Need help?
General
