Taurus BT-PG 2000/1 - Oil Change and Level Check; Automatic Oil Cut-out

m
• Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
• We recommend that you clean the device
• immediatelyeachtimeyouhavenishedusing
it.
• Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the
plastic parts of the equipment. Ensure that no
water can seep into the device.
7.2 Air lter
In this connection, please also read the service
information.
• Cleantheairlteratregularintervals,and
replace it if necessary.
• Open both clips (Fig. 5/A) and remove the air
ltercover(Fig.5/B).
• Removethelterelements(Fig.6/C)
• Do not use abrasive cleaning agents or petrol
to clean the elements.
• Cleantheelementsbytappingthemonaat
• surface.Incasesofstubborndirtrstclean
with soapy water, then rinse with clear water
and airdry.
• Assemble in reverse order
7.3. Spark plug (Fig. 7)
Check the spark plug for dirt and grime after 20
hours of operation and if necessary clean with a
copper wire brush. Thereafter service the spark plug
after every 50 hours of operation.
• Pull off the spark plug boot with a twist.
• Remove the spark plug with the supplied spark
plug wrench.
• Assemble in reverse order
7.4 Changing the oil and checking the oil level
(before using the machine)
The motor oil is best changed when the motor is at
working temperature.
• Only use SAE #30 4 stroke motor oil.
• Place the generator on a slightly inclined
surface so that the oil drain plug is at the lower
end.
• Opentheoilllerplug.
• Open the oil drain plug and let the hot engine
oil drain out into a drip tray.
• After the old oil has drained out, close the oil
drain plug and place the generator on a level
surface again
• Fill in engine oil up to the top mark on the oil
dip stick (approx. 0.6 liters).
• Important: Do not screw the dipstick in to
check the oil level, simply insert it up to the
thread.
• Dispose of the waste oil properly.
7.5 Automatic oil cut-out
The automatic oil cut-out responds if there is
too little oil in the engine. In this case it will not
be possible to start the engine or it will cut out
automatically after a short period of time. It cannot
be started again until the engine oil has been topped
up (see point 7.4).
8. Disposal and recycling
The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
TAURUS
®
is a registered trademark of ALDI Stores.
ALDI Guarantee
Specially made for ALDI Stores to our stringent
qualityspecications.Ifyouarenotentirely
satisedwiththisproduct,pleasereturnittoyour
nearest ALDI store within 60 days from the date of
purchase for a full refund or replacement, or take
advantage of our after sales support by calling the
supplier’s Customer Service Hotline.
03/2011
12
After Sales Support TEL: 1300 922 271 EMAIL: service.australia@einhell.com