ECO speed.
the brush vacuum’s main body (E). (Fig. 2)
switch. (I)
FITTING AN ACCESSORY TO THE HAND
VACUUM:
the brush vacuum’s main body (E). (Fig. 2)
that it allows the following accessories to be
requirements). (Fig.3)
end, which brushes the surface as it is used.
PARKING POSITION:
comfortable and straightforward storage.
FOLDING HANDLE:
easy storage. (Fig.4)
CLEANING
cool before undertaking any cleaning task.
few drops of detergent and then dry it.
base pH such as bleach, or abrasive products,
for cleaning the appliance.
other liquid, or place it under a running tap.
EMPTYING THE DUST BOX:
though the transparent walls, when it is full, or
when the vacuum cleaner does not work to its
full potential.
the brush vacuum’s main body (E). (Fig. 2)
Disconnect the dust box from the appliance. (Fig.
5)
container.
To reassemble, follow the above instructions but
in reverse.
CHANGING THE FILTERS:
the brush vacuum’s main body (E). (Fig. 2)
(Fig 5)
instructions, in reverse order.
CLEANING THE ROTARY BRUSH:
the motorized brush. (Fig. 7)
brush.
the cover with the tabs on the front and press
until you hear the click.
SUPPLIES
for your appliance model.
cally for your appliance model.
HOW TO REMOVE THE BATTERIES FROM
THE INTERIOR OF THE DEVICE:
Caution: It is important that the batteries are
fully discharged prior to its withdrawal from the
apparatus.
Caution: the appliance must be disconnected
from the mains when removing the batteries.
TO REMOVE THE BATTERIES, ONCE THE
LIFE OF THE APPLIANCE, PROCEED AS
FOLLOWS:
screws (Fig 8)
residual power in the battery, after cutting each
cable use insulation tape to protect the tip. (Fig
8)
To Next Page
Loading...
